4-Piece Kit Includes:
• 1 - SMALL (7mm Width) Right
• 1 - SMALL (7mm Width) Left
• 1 - LARGE (8mm Width) Right
• 1 - LARGE (8mm Width) Left
• 1 application handle
$195
8-Piece Kit Includes:
• 2 - SMALL (7mm Width) Right
• 2 - SMALL (7mm Width) Left
• 2 - LARGE (8mm Width) Right
• 2 - LARGE (8mm Width) Left
• 1 application handle
$295
1. Prep: Etch and prime (seal) the tooth and fill
the Mold-A-Lateral™ with light-cure resin.
2. Seat:Seat to try-in the Mold-A-Lateral until incisal edge aligns with centrals.
3. Cure: Light Cure 10 to 20 seconds, depending on material and light intensity.
4. Remove: Remove the tip
of the Mold-A-Lateral.
5. Finish: Use a finishing bur for final contour adjustments.
Just 5 steps in 5 minutes! Transforms an undersized lateral to a full size lateral to hold the space required for a permanent restoration after treatment.
Studies show that approximately 8% of orthodontic patients have either a peg or undersized lateral. During the entire course of treatment, the orthodontist must continuously use coil springs to maintain the correct amount of space for the final restoration. Brackets don't always stay
securely on the tiny anomalous laterals, so the clinician must waste precious time re-bonding the brackets.
The Lateral Bonder Mini-Mold is an easy technique and requires few — if any — adjustments when following the directions provided. The molds are
re-usable.
The Lateral Bonder Mini-Mold provides you with another service that many patients are happy to pay for.